Setting up a Brick Paver Walkway or Cement Bricks

The use of Installing a Brick Paver Walkway or Face Bricks or Pavers to produce a walkway or patio area complements a house in a manner in which is unrivaled. It adds a level of quality and sophistication to a home entrance that can not be attained with either concrete or asphalt. Brick and Pavers likewise are available in various colors and shapes permitting for unique color pattern and patterns to be achieved. In addition, setting up a Brick or Paver sidewalk does not necessarily need a pro. With some standard understanding and a fairly basic sidewalk strategy, a homeowner is capable of undertaking such a project.

The key to setting up a Brick or Paver Walkway is to first properly prepare the area where the bricks/pavers are to be installed. The area must be removed at least a foot down, getting rid of all topsoil and clay soil. In addition, string lines should be strung on each side of the sidewalk. The string lines suggest the finished height of the sidewalk.
Once the location has been dug down, 3/4" gravel stone should be laid in and tamped down firmly. The height in between the tamped down sand and the stringline ought to equate to the density of the brick or paver.

Now that you have a steady base, put a 1" pipeline or ledger board the length of the sidewalk on either side of the walkway. Then utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will produce a level area to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Set up an operate on both sides of the prepared area. These strips will act as your sidewalk border and help to maintain the stability and shape of the pathway. You can get these plastic strip loose bricks borders at most house enhancement stores. The strips ought to be anchored down with 12" galvinized nails. You must sink these nails into the ground and through the strips every foot.

The key to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will once again assist preserve the stability of the sidewalk.

Undoubtedly bricks/pavers will need to be cut or divided when developing the sidewalk. To in fact cut/split the brick/paver, lay it in a bed of sand and location the sculpt at a 75 degree angle over the spot where you desire to break the brick. If your pathway has curves you will need to buy/rent a wetsaw.

After installing the bricks, construct up the outside edges with extra sand, and then shovel in the topsoil and pack down securely.
Finally, spread stone dust over the new pathway and sweep into the fractures. Repeat this process a couple of times to make sure the cracks are fully filled. This will finish the interlocking of the bricks and help to remove any weed development. Just include grass seed to the outdoors edges and you must have a stunning entrance to your house within a couple of weeks.


In addition, setting up a Brick or Paver pathway does not always need a pro. The key to installing a Brick or Paver Walkway is to very first properly prepare the area where the bricks/pavers are to be set up. Now that you have a stable base, position a 1" pipe or journal board the length of the walkway on either side of the pathway. These strips will act as your sidewalk border and help to keep the integrity and shape of the pathway. Undoubtedly bricks/pavers will need to be cut or split when constructing the walkway.

Leave a Reply

Your email address will not be published. Required fields are marked *